Watson-Ethernet-Manual.doc
Version 3.3-01
Watson Ethernet
Operating Manual
CARDMODE [ mode ]
The Watson Ethernet plug-in can be configured flexibly to support 1/2/4 pair op-
eration. This is done with the CARDMODE command. Entering CARDMODE without
any parameter will display the current plug-in mode:
LTU_01_CM> CARDMODE
Current cardmode: 4x1 pair (mode 1)
Bridge Port Wire Pair
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
DSL1 <-------------> a1a2
DSL2 <-------------> b1b2
DSL3 <-------------> c1c2
DSL4 <-------------> d1d2
Available CARDMODEs:
4x1p, four independent 1-pair systems
2x2p, two independent 1-pair systems
1x2p + 2x1p, one 2-pair and two 1-pair systems
When changing the cardmode, the newly configured DSL spans will be reset and
their configuration set to the default configuration of the new mode as defined in
Table 7-2. Note that only the DSL defaults are set, the Ethernet interface confi-
guration is not changed by CARDMODE. For security reasons, the command must
be confirmed.
The Watson Ethernet tabletops have no card mode.
Kommentare zu diesen Handbüchern